Start With the Symptom
A drip from the spout usually means a worn cartridge or seal. A weak or sideways spray usually means a clogged aerator. A stiff handle or one that will not stay in position often means a worn or mineral-coated cartridge.
Match the symptom to the part before you buy anything. Replacing the wrong part wastes an afternoon.
Symptoms and Likely Parts
The cartridge is the heart of most single-handle faucets.
| Symptom | Likely cause | Typical fix |
|---|---|---|
| Drip from the spout | Worn cartridge or seals | Replace the cartridge |
| Weak flow | Clogged aerator | Unscrew and clean the aerator |
| Stiff or gritty handle | Mineral buildup in the cartridge | Clean or replace the cartridge |
| Leak at the base | Worn O-rings | Replace the O-rings |
| Hot and cold mixed wrongly | Cartridge or supply line issue | Check the cartridge position and supplies |
Replacing a Cartridge
Each model differs, so the model number or the old part is your guide.
- 1Shut off the waterClose the stops under the sink and open the faucet to relieve pressure.
- 2Plug the drainCover it with a rag so a screw or small part cannot fall in.
- 3Remove the handleLook for a small cap or set screw, then lift the handle away.
- 4Pull the old cartridgeTake off any retaining clip or nut and draw the cartridge straight out. Note its orientation.
- 5Match and fit the new cartridgeBring the old one to the parts counter, or read the model number on the faucet, and install the matching cartridge.
Cleaning the Aerator
An aerator is the small screen at the tip of the spout. Mineral grit and debris collect in it and reduce flow. Unscrew it by hand or with a cloth and pliers to protect the finish, then rinse the screen and soak it in vinegar if it is crusted.
This five-minute job fixes more weak-flow complaints than anything else.
Repair or Replace?
A premium faucet is worth repairing when the body is in good shape and only a cartridge or seal has worn. If the finish is peeling, the body is corroded or the faucet leaks from the casting, replacement makes more sense.
When you do replace one, plumbing installation covers fixture work, and the faucet repair page explains how we decide between repair and replacement.
Finish Care for Premium Fixtures
A chrome or brushed finish lasts longer when you clean it with a soft cloth and mild soap. Abrasive pads, harsh bathroom cleaners and bleach strip protective coatings and leave dull patches. Rinse and dry the fixture after cleaning.
If a finish has already pitted or peeled, no cleaner will restore it. That is a good moment to weigh replacement against a repair.
When the Problem Is the Supply
Sometimes the faucet is fine and the trouble sits upstream. A partly closed stop valve, a clogged supply line or low household pressure all mimic a bad faucet. Check the flow at another fixture before you take anything apart.
Braided supply lines wear out too, and a bulge or a rusty fitting means it is time for a new one. Replace them when you replace the faucet, since the cost is small and a failure can flood a vanity.
Tools and Care Before You Start
You need an adjustable wrench, a flat and a Phillips screwdriver, a hex key set and a rag for the drain. Lay a towel in the basin so you do not scratch it or lose a small part. Keep the removed parts in order on the towel so reassembly is simple.
Photograph each step, especially the position of the cartridge and any clips. If a part is stuck, do not force it with a wrench. A little penetrating lubricant and patience usually works, and a stripped handle screw is a reason to call.
Signs You Should Call a Plumber
Call if the leak is inside the wall, if the stop valves do not shut off or if you see corrosion at the supply connections. Call if the faucet is part of a widespread set and you cannot find the model. A drip you cannot trace is worth a visit before it becomes a water stain.
A plumber also tests the shutoffs and the supply lines during the visit, which prevents the next surprise.
Mineral Buildup in Shrewsbury Faucets
Shrewsbury's water comes from groundwater wells, and groundwater carries minerals that can leave a crust on aerators and inside cartridges. How much depends on your supply and your fixture.
The town water department publishes a yearly water quality report. Ask for it, or test your tap, to see what is in the water that reaches your bathroom.
Faucet Past Saving?
Call us and a plumber can repair the fixture or replace it, then test every connection before leaving.
Nearby Towns
Callers in Grafton and Westborough ask about the same faucet problems.
Faucet Repair Questions
Look for a model number on the faucet or in the manual, or bring the old cartridge to a plumbing supplier.
The valve seat may be worn, or the cartridge may not be seated correctly. A plumber can check both.
Yes, if the fixture has working stops under the sink. If it does not, the main shutoff is the next option.
A cartridge swap takes under an hour for most fixtures once you have the right part.
Minerals can wear cartridges and clog aerators. Ask the town for its water quality report to see what yours carries.
